This post has been a long time coming, and was delayed by the post about the battery box as well as some sudden health issues my partner and I’s furry companion was dealing with. Unfortunately this would be one of his last trips he took with us but it was extremely enjoyable and we had a wonderful time exploring / sniffing everything depending on who you were. Loki was an incredible companion who visibly cared about not just the humans he lived with but all humans, especially folks that were sad or distressed. He is deeply missed by many around him. Rest in peace Old Man.
As we have been exploring with our vehicle I’ve also been testing various scenarios operating the radio. I wanted to see if I could hit the K7LJ repeater on Mt. Tabor in Portland from this camp site so I set up my portable antenna mast, connected my radio to the newly-constructed 100Ah battery box. I messed up connecting the radio at first, but later saw my current draw while the radio was idling was higher than expected and fixed the issue. More on that later.
The net went fine and I had a decent signal report, but my audio was a bit low due to the headset I was using. Increasing the sensitivity resolved that issue after the net had concluded. I’ve noticed that specific Heil headset tends to require more preamplification to produce quality audio for recieving stations on most of my radios. This specific site was somewhere around CN85ho17.
I was able to reach the repeater with little issue and a decent signal report. Being this far out and in the mountains that was a pleasesent surprise.
At this point it’s worth pointing out a mistake I made when connecting the radio to the battery. I saw about 1.5A of current draw when I was expecting to see about 0.6A. It’s important to make sure you connect the battery to the radio and to make sure you’re not energizing your vehicle’s electrical system with the battery. You can easily damage things and burn fuses out if you do that. I noticed the current draw was higher than it should be if I were just powering the Kenwood TM-D710G and investigated the electrical setup. I had disconnected the wrong end of a “Y” cable that splits between the Kenwood radio and the CB radio I use for offroading/trails. I had accidently energized the vehicle’s electrical system when it had some accessories powered on. Lesson learned.
